Voicelok Setup Video
 
    
                                 

Accessing Setup Mode for the First Time

Insert Voicelok into computer
Press trigger to activate color code input
Voicelok will flash both LEDs rapidly for 1 second
LEDs will cycle through RED/GREEN/RED+GREEN patternEnter RED/RED/RED/RED/RED/RED (press trigger when RED LED cycles through)
Both LEDs will flash rapidly for 2 seconds; press trigger DURING flashing to enter SETUP mode
 

While in Setup Mode— Training Voice Password

Say voice password; GREEN LED will flash rapidly  
Say password again; GREEN LED will flash rapidly
A solid GREEN LED indicates that voice password has been stored; a solid RED LED indicates that
there was a problem storing the password; repeat until solid GREEN LED achieved
 

While in Setup Mode —Training Color Code

The LEDs will start cycling through RED/GREEN/RED+GREEN pattern; press trigger on the color desired for color code  
Repeat five additional times
 

Using Voice Password

Insert Voicelok into computer  
When red LED flashes regularly, say voice password; both LEDs will flash rapidly for 2 seconds to indicate correct password
 

Using Color Code

Insert Voicelok into computer
Press trigger to activate color code input
Voicelok will flash both LEDs rapidly for 1 second
LEDs will cycle through RED/GREEN/RED+GREEN pattern
Enter color code by pressing trigger when appropriate LED cycles through
Both LEDs will flash rapidly for 2 seconds to indicate correct password
 

Accessing Setup Mode

Enter voice password or color code; both LEDs will flash rapidly for 2 seconds
Press trigger DURING flashing to enter SETUP mode

FAQs

Why isn’t my password being accepted?
It might be too noisy, or your voiceprint has changed too much (triggered by lack of sleep, stress, illness)—try using different tones of voice.                                                                                                                                          
What passwords work better?
Short phrases that are tonally distinct would be ideal. For example, “Wrench Monkey” or “1381” is a good password while “Bye bye” or “Hi” would be too simplistic.      
I accidentally interrupted the setup process, how do I access drive?                                                                       
In the event of an interruption during Setup, the color code sequence defaults to “Red-Red-Red-Red-Red-Red”.